kelly saad
Supporting Vendor
Here we go with vehicle # 3. This one has more rust that the last 2 vehicles, so it should be entertaining.
The project:
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Prep jambs.
3. Repair rust in rocker/lower fender.
4. Close all holes in rocker panels from trim, and fill holes in roof from roof rack holes.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels, Lower tailgate replacement panel. Sand blast remaining rust, seal bare metal with POR-15, new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. New cowl/lower windshield repair panels (3 sections) the entire lower windshield area. Lots of rust here.
9. Remove existing filler on passenger rear door and upper quarter panel from accident, repair poor, previous body work.
10. Paint jambs and install doors, hatch and tailgate.
11. Exterior paint, B/C, wet sand, and polish.
The project:
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Prep jambs.
3. Repair rust in rocker/lower fender.
4. Close all holes in rocker panels from trim, and fill holes in roof from roof rack holes.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels, Lower tailgate replacement panel. Sand blast remaining rust, seal bare metal with POR-15, new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. New cowl/lower windshield repair panels (3 sections) the entire lower windshield area. Lots of rust here.
9. Remove existing filler on passenger rear door and upper quarter panel from accident, repair poor, previous body work.
10. Paint jambs and install doors, hatch and tailgate.
11. Exterior paint, B/C, wet sand, and polish.