I lost my test fit vehicle. I have all the parts but no 200 to fit it onto. I haven’t tried to ask around for another test vehicle though because I’m so busy.
Yes actually. I’m planning out some time to design the 3rd gen 4 runner and 1st gen Tacoma. Hopefully they will be popular and not a waste of my time. I measured both and confirmed that the 7” round with the headlight bracket will fit.
Haha! It is part of the plan. I want to make a conversion to 7" round for the 62 and I would like to make 62 bezels also. I need more time in my day :meh:
Here is the schedule for 2022. At this point we will meet at the shop 1819 N Center st #101 86004. We can determine alternate locations later, but keeping this as home base. Also, We will plan some trail runs. :)
April 15th
May 13th
June 17th...
I made a patch. It's the most difficult one that I have tried to make. Multiple curves and a body line that goes through the bends. Super tough. I think a couple more attempts and it will look good. A different fender would be best though for...
Apparently all I had to do was flip the connectors the other way. So backwards of how they would typically slide in. Aaron on facebook saved my life thanks dude!
Chris and I are having a HIH Board Meeting right now..... both board members are present and accounted for.
Expect a full announcement within the next week.
HIHX Coming Soon.....LFG!
_
I'll be in Silverton during the event one way or the other. I'm leading about 8 guys out from the east coast. Don't know if we will get everyone registered or not. I hope so. It would be great to see everyone again!
Hey all, if anyone still follows this thread, YES we are actively working on getting HIHX, the big #10 up and going. Shooting for online registration within the next two weeks. Will post more here. May start a new thread, @paflytyer would do...
Well I de-poseurfied it a bit with some TRD Pro wheels, 265/70/17 31.5" BFG Trail Terrain tires and put the rack back up in storage.
Losing the the steelies and C-rated 33" BFG KO2s shaved ~37lbs per corner in rotational/unsprung weight -- 25lb...
thanks! @kelly saad and @WSOPgold2012 for the hard work...I'll add
Hood insulator 5334160100 1 $116 TPD...53341B here is the right FJ62 hood insulator the other was for an 80)-haven't purchased yet not 100% if still available but several sites...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.