My 04 has developed a crank-no start issue. It’s had a fair amount of maintenance performed over the past 2 years. Below is everything that’s been checked/repaired
- New fuel pump + strainer (08/2025)
- Battery replaced (04/2025)
- VCGs, axles, plugs checked (03/2025)
- Timing Belt + water pump (07/2023)
No codes are shown in my cheap handheld reader. Tank has 20+ gallons in it. Engine will start briefly with starting fluid, but dies in a few seconds. Fuses for EFI have been replaced and relays have been swapped; no change in starting.
I can’t imagine a fuel pressure regulator would cause it to not start at all, am I wrong? Which pins in the relay need to be jumped to check to make sure the pump is functional? I tested both the old and new pumps with 12v and both work; however, the old one was noticeably noisier.
Thanks in advance for any help you can provide!
- New fuel pump + strainer (08/2025)
- Battery replaced (04/2025)
- VCGs, axles, plugs checked (03/2025)
- Timing Belt + water pump (07/2023)
No codes are shown in my cheap handheld reader. Tank has 20+ gallons in it. Engine will start briefly with starting fluid, but dies in a few seconds. Fuses for EFI have been replaced and relays have been swapped; no change in starting.
I can’t imagine a fuel pressure regulator would cause it to not start at all, am I wrong? Which pins in the relay need to be jumped to check to make sure the pump is functional? I tested both the old and new pumps with 12v and both work; however, the old one was noticeably noisier.
Thanks in advance for any help you can provide!