Hello, this part is discontinued by the manufacturer. I own a KZJ78 and need a replacement for the socket behind the fog light. Does anyone have a new one or non-corroded working socket they are willing to sell? Thanks
part no:
81515-60403
Wire Sub-Assy, Front Turn Signal Lamp Body...
Far left instruments would not illuminate when headlights were on. Removed instrument cluster today and found a melted lamp socket housing(see below). I have been scouring the web, but can't seem to find a replacement lamp socket housing. "Yazaki" is inscribed on the back of the housing...
Not being a 24v grandmaster quite yet.. how are these housings different aside from the connectors? For a 12v FJ62 vs a 24volt Hj61 front fender turn signal lamp housing. The rubber housing have deteriorated on these necessitating a replacement due to my overly anal and pedantic nature. Toyota...
Hello everyone. This Canadian 24volt BJ42 has several lamps missing in the rear. Can anyone tell me the lamp numbers for turn, tail/stop, and backup? Thanks
( NEW PRODUCT RELEASE )
NOS General Service / Room Lamp Switch
W/ OEM Protection Boot & OEM 2pin Rubber Bullet Kit
84270-60010 / 84270-60020 / 84270-60030
Note : does not include wire itself …. Fyi
NOS General Service / Room Lamp Switch W/ SNOW VERSION Insulator Protection Boot &...
Hey all,
Has anyone tried swapping out the bulb for their 16+ LX? My understanding is that the unit is an entire sealed assembly so if, for example, the LED went out, you'd have to replace the entire thing.
However, I want to switch to a yellow bulb. I know lamin-x makes a cover for the fogs...
Hello!
Part #’s 81518-60412, 81520-60282
I ordered these per the diagram for my 1994 FZJ73 and they are incorrect for my truck. These are the smaller ones that mate up with the grille that wraps around more on the sides.
Through Partsouq they were $82ea plus a bunch for shipping.
I guess I’d let...
Toyota wants around $10 each for those little 1/4 turn bulbs that are used in the PRNDL cluster, the climate control, and most of the buttons. I finally found a reasonably priced alternative on Mouser: Mouser PN 560-DNW1-DW33 (manufacturer PN DNW1-DW33. $1.18 each. Shipping was $4.99...
I'm looking to buy an original inspection light for my 1982 Toyota Land Cruiser HJ47.
Attached are pictures of one that recently sold on Ebay for $290.
I would pay more for one in similar condition or less for one without all the extras. The inspection light has to be working and have plug...
I have two 24V inspection lamps with blue bags for sale. These are the later ones with black chord and yellow cad plated hardware. One bag has a bluer tint to it than the other (I don't believe this is the heavily tinted blue bag found with earlier brown chord lamps) and has a small tear along...
Hello all,
I had my '11 LC undercoated with Krown undercoating yesterday. I didn't notice this issue until today, but the little black tabs on the front bumper that raise up and wash my head lamps are not working and are stuck in the up position. When I press on one end, the other end goes up...
With the 100 Series a single wire in the master light switch can be modified to allow use of the fog lamps in expanded scenarios, i.e. run them in park, low beam or high beam. Has anyone figured out such a thing with the 200?
As stated, looking for a good condition DRIVERS SIDE turn signal lamp. My tab is broken and the lamp plastic is cracked.
Would also entertain a pair so they're both "evenly" worn
Shipped to CT - 06611.
Have 3 brand new Hella wiring for Rallye 4000 lights.
Great wiring set that would work for any other similar lights.
Made in Germany
Asking $40.00 plus shipping (each)