Deathvalleypaul

of course! Brown or Grey?

I am out of them right now. Contact Gineric on Mud. He may have them.

FJ80 - not compatible with 93-97 80 series, only fits FJ80s 1990-1992 and CABLE DRIVEN Euro and JDM Gas/Diesel 80 series. Cluster includes guages, tachometer and speedometer. Mileage can be reset by any speedo shop to whatever you request by...

FJ80 - not compatible with 93-97 80 series, only fits FJ80s 1990-1992 and CABLE DRIVEN Euro and JDM Gas/Diesel 80 series. Cluster includes guages, tachometer and speedometer. Mileage can be reset by any speedo shop to whatever you request by...

FJ80 - not compatible with 93-97 80 series, only fits FJ80s 1990-1992 and CABLE DRIVEN Euro and JDM Gas/Diesel 80 series. Cluster includes guages, tachometer and speedometer. Mileage can be reset by any speedo shop to whatever you...

Eric, I agree. It is a major pain in the a. I did it once before and would almost prefer to buy a new housing.

I no longer have one. Using a gasket for the locked front axle as a pattern, a non-locking axle can be modified to accept and hold the locker itself. Toyota carries the gasket for 97LX450. Otherwise it is very difficult to find a locked housing.

I can ship anything on your dime, however the shipping on the front bumper is extremely expensive, not just expensive, and I am speaking of over $200. The rear bumper corners ship for about $50 to $60 each due to their length and width. An...

Yes, I can ship it to Idaho. My guess is about $500 for shipping. When added to the cost of the transmission, this is not cost effective, even though I want to sell what I have, you might as well look for local or have yours rebuilt.

I have your fender and plenty of doors. I do not have the flare, but make sure you use a flare from similar groups: 93 and 94 interchange and fit holes on 93 and 94 fenders. 95-97 interchange and fit holes on 95-97. Your mailbox is full!

94 flare will not fit on your fender without redrilling the flare holes as it mounts completely different. 93 and 94 fit both years, and 95-97 are all the same mounting holes and all the same flares.

$350, just like a new factory bumper. complete with brackets

I have a nice LX450 passenger headlight. Mounting tabs have been repaired and appearance is very good. $150 for headlamp and $25 to ship it. Deathvalleypaul.

80 series Fits 91 to 94. It came off a beautiful early model. Complete with mounting brackets etc. Bumper ends were trimmed 4 larger tires. No rust or dents. Ready to mount. Rear bumper corners also available. All 4 corners have the chrome trim...

Yes, Annie gave it to me to sell for her. It is new, and as pictured. I can ship it today to Friday, then gone for 8 days 4 wheeling. Paypal as Gift is accepted, and Zellepay is also possible. I will need your city and zip code to get a...

From a 96 with a good engine and cool AC system. $100. This is a whole lot better than trying to fit an aftermarket one in, they never seem to fit right.

Yes, complete with torque converter. I drove the Cruiser it shifted very smoot and no jerks or chatter. It is out of the car now which got parted out and ready for pickup.

Next step was the climate control. The vent position switch never worked, and the buttons were in bad shape. I got a 40th anniversary climate control on Facebook, and ended up using the circuit board from the US domestic climate control, as well...

From a 96 FZJ80. Tires are included at no extra charge. Wheels are in used condition and show nicely. $450. NO SHIPPING. I am in the San Gabriel area near El Monte.

Yes I do, local pickup only in Pasadena, Arcadia area

Nice set of four 16 inch used 80 series factory wheels. Local pickup in SoCal Near Pasadena San Gabriel area. New set of lug nuts included. No charge for the tires, there are no any center caps. $500 for all 4. Local pickup only.

Please see your personal message. I can cut to suit.

No, Most SoCal cars dont need them so I have yet to see one.

see your personal message