Hello,
As some of you may know I have retro-engineered and designed an electronic replacement for our beloved superglow systems (see Superglow electronic replacement - https://forum.ih8mud.com/threads/superglow-electronic-replacement.1323121/). The manual is available here .
I initially made...
Last weekend we put in a new sending unit. The FJ cranked right up and and drove around no problem.
This weekend we were doing some more work on the suspension and we could not get it to crank. We are not getting any fuel from the fuel pump up to the carb. We pulled the air filter off the...
been thinking about getting one for battery testing. I'm considering going 400W in case I want to test biggish solar panels at some point, but those are pricy. So, 200W it may be. (Although it appears that some may be upscaled in power with just some software instructions.) I'd want...
Did a quick search and couldn't find a thread for identifying all the various electronic connectors, in this case a capped connector, passenger side rear near the bumper. Anyone have an idea what this might be for? US Spec 2009 LC. Dont mind the dirt. :-)
Hello everyone,
Been on here a little but military life has been getting in the way of me digging into my LC. I've finally got back to the states again and have time to get some stuff done.
I have done some searching on here and other places online and am trying to find if aftermarket...
My 92 Hilux has an electronic speedometer. When the driveshaft came loose it obliterated the pigtail that attaches to the sending unit on the trans. The wires are there, but the colors don't match up with what my Aussie Haynes manual shows. I'm looking for a pigtail locally, but even once I...
After enduring too much trouble with my original superglow timer which frequently did not operate correctly I decided to use my electrical engineering knowledge to make a timer replacement.
This board is based on an ATMEGA328P for the logic part.
Current features support:
- Water temperature...
1971 FJ40, F engine with Nippon Denso 19100-60061 dizzy.
I am trying to make the switch from points to electronic ignition. Running this vac advance dizzy which runs good.
I am looking for a correct PN for a good electronic system that will fit this distributor base.
I tried the Pertronix...
I hope this question doesn’t seem too stupid but I’m assuming this is an electronic fuel pump in front of my fuel filter? I installed a new carburetor and it ran like a top and all the sudden it won’t start. It doesn’t appear to get any gas to the carburetor. I’m gonna change the fuel filter...
looks like these are different then the USA FZJ80 ones for some reason they made range very slightly different. I'll buy the whole instrument cluster if need be but i only need the speedo. pobibly would have to be from a UK truck.