I bought OEM MLS-type head gasket to my 1981 BJ42, part no. 11115-58110.
I assumed it’s just bolt-off and bolt-on. Then I found this from Radd Cruiser’s website: 3B & 13BT MLS Head Gasket 11115-58110-AM - https://www.shopraddcruisers.ca/mls-head-gasket-3b-13bt-11115-58110-am.html
Well, how...
Hello. Would it be just so easy to change the original wiper switch to this and get intermittent wiper function to -81 BJ42 (Euro-spec 24V):
Edit: There is said ”negative ground only”, so because the original switch just ground the motor (not feed power to it), I think there is relays needed...
Do anyone know what’s wrong with japan-parts.eu site? No answer, over week is gone without any sign of working.
This is/was my best online part number search.
Edit: 11. December it works again
I’m just about installing turbo to my 3B and try to learn how to adjust the inline fuel pump the right way. I’d like to keep the economy and avoid increasing fuel to the power band where it’s not needed, but there should be the possibility to get all needed fuel when floored.
I have never seen...
I am planning to widen the front fenders about 2” to get 12.50” tires under the fenders.
How you have done it? Where is the best line to cut? Straight or follow the side panel?
What’s wrong? Left side blows warm good enough, but at the same time right side blows almost cold. I can feel at the center vents too, the left side blows hotter than right. The blow is about the same.
I checked the cabin air filter, it’s good. The air flow selector works, aiming changes like...
Hello
What is the situation of the hand brake crank pivot bracket, is the desing changed or what?
The part has been superseded from 47628-35010 to 47628-35020.
I took apart my old one and noticed there is some insert there which is missing from the new OEM part.
Found this picture too from...
Is anyone tried how close is SEM 15173 vinyl paint vs. CC coral color seat covers? Or do you have better products/closer match in mind?
I´d like to get the door panels and center console match to the seat covers.
The front part is rusted through. How to fix?
And an other spot in the middle:
Otherwise it’s ok. I’m thinking sand blasting and a two-part epoxy panel bonding adhesive. Would it last?
How much should this distance to be? The quarter panel’s level surface to the top of the B-pillar? Exact please. Thank you!
I forgot to measure before cutting the edge. :(
Have anyone seen these or even drive with these? Any experience? I didn’t found any decent review or pictures how they move (fully extended/compressed).
Would these work in 40-series with lift springs? Could these help if shackle angles are bad?
So, I ordered new seat covers from Cruiser Corps. The front ones are ok, looks great, but the rear ones for the jump seats are way too small. They supposed to be for 1979-1984 FJ40, BJ (500-115a). I didn’t thought it more, but now I noticed there is different model jump seats for models with the...
How is the ride with Rough Country N2.0 shocks? I know the 4” springs are hard (without removing leaf(s)), but what’s the situation of the shocks alone? They are nitrogen charged and should be way better, not so harsh, than previous 2.2 version. N3 is released too, looks about similar except...