Just had this problem on really cold starts—turned out it was my radiator cap to venting properly—although coming to this conclusion was a pain in the ass
I have not pulled the trigger as of yet—really waiting on Wits End setup and see what price range that will be guessing 4-5k but with very minimal rust on my rig and only 185k I’m in it for the long haul—hopefully my kids first car
So your saying that its a 4.75MM OD, I tried using 3/16 and compression fittings but fittings would go over original brake lines. I only need a couple ft that is why I was going to go this way, did you order 4.75MM lines and if so from where? Any advice would be great, thanks.
Thank you for the note—I have no interest in doing it that way but appreciate the idea—I am just going with all OEM hard lines and doing my axle to caliper lines while I do do rotors and brakes...just never seen any info on this, also finding the OEM lines has been a bit of a challenge as well
96 LC and my hard line on the driver side about 3/4 way back has corroded through. A couple questions, should I just replace with OEM, also any advise on tackling the project? I have searched through the threads and their really wasn't any pertinent info pertaining to replacing. Thanks in...
Thanks for the info--I was more curious than anything, but that was a great breakdown-- have made all the interior, and exterior upgrades and while my engine runs strong, I would like a little more pep. I think a setup with 6-10lbs would be manageable without to much modification, as i have...
Ive been through all the old threads but can't find anyone that has actually bought and reviewed this Turbo set up from these folks. The price suggests cheap import, but still peaked my curiosity.
T4 T70 Turbo Intercooler Kit For Land Cruiser J80 1FZ-FE 1FZ 1FZFE
Acquired a 96 LC FZJ a couple months ago. I have been reading a lot of the rookie tips and tricks but one thing keeps coming up about lockers that I can't find. While my 96 does not have the switch to the left of the steering wheel I read on Slee that it still may have factory lockers just not...
No problem—they take a good amount of time to put on but are worth it—I also didn’t use the botttom loop on the sides as it lets the cover sag more into the back and seat.
Looking into options with my leaky exhaust. I have a couple holes before the Cat and after--also small leak on the side of CAT. Its all original exhaust and the muffler does not have any issues, my question is should I replace the entire exhaust or just engine to muffler--also does anyone have...
Added some Duluth Trading seat cover to the 80, very tough to get on but they are extremely durable—they do cover up the seat controls only downfall—all in all very happy with them, and i think they look great!!