the hayull outta anywhere near my wires.
I’m not worried about gas mileage or any other concerns. I’m just worried for my wires.
Now that I’ve got that out of the way, has anyone simply cut the pipe down low (remove front left wheel and starter to get low enough) and fill the stubby leftover...
My question:
Will resetting the stability control (with two paper clips in OBDII port hack) fix this problem or is this definitely a bad Yaw Rate sensor?
I have the 2002 model. For those who don’t already know, these two years were equipped with a transfer case that’s center diff would only lock when in 4WD Low Range and the transmission column shifter in “L”. The problem with this is that if/when you manage to get the CDL engaged while in Low...
“Lower ball joint upgrade”, as in upgrading the first gen sequoia LBJs to a better system (Land Cruiser 100, 2nd gen sequoia, etc…)
Any suggestions would be greatly appreciated.
Before y’all jump me, I searched for ARB switch upgrades and found nothing.
Anyway, my first generation airlocker switches are on the blink. Ya gotta wiggle them to get them to work half the time. So it’s really a pain when hitting a tough hill climb and reaching down to push the switches then...
I’m not new to mud, as I’ve been here for years on the 80 series forum. But I’ve recently bought a 4wd 2002 Sequoia and figured this board could lead me in the right direction, since a Sequoia is a kissing-cousin of the 100 series LC.
My question: Is it possible to bolt up an FJ Cruiser...
I’ve been thinking about this recently. My ‘81 Scrambler has an early model corvette master cylinder that works four disc brakes. Works GREAT with 40” tires.
That got me thinking about doing the same in my ‘94 Cruiser.
Has anyone tried this?
I’m in that Lexus cheap and can part out all the other parts and still come out okay. Only concern is how hard is it to slap a transfer case on the LS460’s 8 speed transmission?
So I’ve been trying to figure out which one is better.
Typically when a manufacturer changes its for the better but some swear by the heavy duty a442 claiming it’s indestructible and therefore the better of the two. Then I’ve heard the 343 argument that it is lighter and robs less power from...
While celebrating the extra hour of daylight I had too much Bulleit and got a little “confused” while wheeling yesterday.
So now I need to repair this and wondering what type of adhesive I should use?
After buying my 80 out of a tow yard with no wheels, I bought these from a tire shop. They are 7”x16” rims (1st pic) and they didn’t come with lugnuts. So far I’ve been running it with the tapered nuts that center the opening with the stud. The problem is I don’t think there is enough thread...