Banjo Cruiser
SILVER Star
I sold my 94 Cruiser 8 years ago and have had daily regrets and daydreams about getting another one. I recently found a 94, zero rust, 199k miles, good price ($18k). Below is the work that has been done by the current owner. He bought it 2 years ago and just never drives it so getting rid of it (2k miles in the 2 years he's owned it)
My biggest concern is that it hasn't been driven much since it was completed and I'd need to get a flight out and drive it back (roughly a 10 hour drive).
-199k Miles
-Factory triple locked
-No Rust
-Rebuilt Trans (2k miles ago) - Previous owner and has reciepts
-Transfer case sealed
-Head Gasket replaced
-Valve job
-Replaced Waterpump, hoses, radiator replaced
-Replaced alternator
--Replaced power steering pump
-Replaced Brakes/master cylinder
-No cats (but don't need one where I'm at)
He sent some videos of it running, some vapor/water dripping out of the tail pipe right after start, but says no HG issue(replaced less than 2 years ago). No known leaks other than a slight one around the valve cover (he did replace the seal).
I'm worried I'm missing something and just looking for a sanity check. Any advice would be greatly apprecaited.
Here is a video of it running.
My biggest concern is that it hasn't been driven much since it was completed and I'd need to get a flight out and drive it back (roughly a 10 hour drive).
-199k Miles
-Factory triple locked
-No Rust
-Rebuilt Trans (2k miles ago) - Previous owner and has reciepts
-Transfer case sealed
-Head Gasket replaced
-Valve job
-Replaced Waterpump, hoses, radiator replaced
-Replaced alternator
--Replaced power steering pump
-Replaced Brakes/master cylinder
-No cats (but don't need one where I'm at)
He sent some videos of it running, some vapor/water dripping out of the tail pipe right after start, but says no HG issue(replaced less than 2 years ago). No known leaks other than a slight one around the valve cover (he did replace the seal).
I'm worried I'm missing something and just looking for a sanity check. Any advice would be greatly apprecaited.
Here is a video of it running.