I drove over the Blue Ridge via Swift Run Gap to get license plates for the newest member of my little RHD fleet.
Could only go uphill at about 40-couple mph but it's good enough. EGT's did not get too high. Boost was off the scale.
Monument...
Some useful heater hoses from Toyota:
99556-30500 is a 500 mm bulk length. You can get less or more by specifying the length you want in the last four digits of the part number.
87245-14500 is a 90 degree bend with about 100 mm of straight...
Speaking of water solutions, I bought one of the slant backed 50L water tanks from Iron Man. In our troop carriers it fits perfectly behind the front seats. I have internal cabinetry that holds it against the seats. If you had nothing back...
Not a lot going on with the cruiser this summer. Been working on my house.
I did order some close-cell foam for padding the lids of the boxes I built for the back.
Cutting with a bread knife went better than a utility knife.
Used the lids as...
Finally I have working ac in my troopy. Had to look for parts from many source, but hardest part was probably the hoses and specially fittings. I wanted to use Toyota's original cooler unit, amplifier and dashboard controls. Compressor, codenser...
The heat right now can't help the seam sealing. Cure time is probably almost instant. Can you dip your finger in mineral spirits to help smooth it if it's starting to cure while your tooling it?
Are you leaving the seam sealer gray?
Getting through my list of winter maintenance. Finally got round to redoing my drivers seat foam, also freshened up the springs and threw a set in out of a 2024 vdj. Handbrake shoes, wheel bearings and swivel hubs and it’ll be set for the next...
Another fun adventure in the books! We had the usual breakage and fix on a couple rigs. A crazy storm rolled through with lightning, thunder and hail!!’ We had a bear come through camp, and my buddy was sleeping outside and said it walked right...