Overhead Welds: Any tips or tricks? I’m just doing some repairs to utility trailer. Replaced a crossmember. 1/8” tube with solid 1/8” slug insert behind. Same heat as flat or should I reduce heat? Wire speed same or faster?
Vertical welds: Some prefer top to bottom. Others bottom to top. I think bottom to top is best way to control puddle?
Welder is an older Lincoln Electric 175 Plus. Using .023 wire since I normally am doing 1/8” and less.
Vertical welds: Some prefer top to bottom. Others bottom to top. I think bottom to top is best way to control puddle?
Welder is an older Lincoln Electric 175 Plus. Using .023 wire since I normally am doing 1/8” and less.