Unofficial Ohio Cruiser parts FS/WTB/trade thread (3 Viewers)

[aging fleet]

edit.... Sold

Just posted 100 series sliders in the classifieds section if anyone is interested.

SOLD - Columbus OH, 100 Series Metal-Tech OPOR Sliders

Purchased new in May 2019 and installed on my LC for approximately 15 months. These were shipped raw and coated with an Epoxy primer and Rust-Oleum spray on truck bed coating. The bed liner held up OK, but it has worn off in spots where they were consistently used as steps. Also, there are...

forum.ih8mud.com

 

[94SRUNNER]

I've got a set of 275/60R18 Michelin Defender LTX M/S tires for $225 and located in Dayton, OH

Additional details and pictures in the thread below.

For Sale - Dayton, OH - 4 - 275/60R18 Michelin Defender LTX M/S

Set of 4 - 275/60R18 Michelin Defender LTX M/S tires. $180 2016 manufacture date. One tire has a patch. They all held air prior to being removed from the wheels. Tread depth on new Defender LTX M/S tires is 10.5/32" or 0.328125" Tire 1 - 0.275" (84%) Tire 2 - 0.200" (61%) Tire 3 - 0.202" (62%)...

forum.ih8mud.com

 

[FJ40Jim]

Looking for a 3FE cylinder head or a complete 3FE to remove a head from?
This is to patch together the 3FE in my cheapo FJ80. The dirtier/highermiles/cheaper, the better.

I have stuff to trade.... like an FJ60/62 full floating rear axle?

 

[FJ40Jim]

I am no longer looking for a 3FE cylinder head.

Free, if you come and pick up.
1991 3FE, fairly complete, but disassembled engine, harness, ECU, badly cracked cyl head, 254k miles, poor maintenance, full of sludge. Did sorta run enough to drive onto trailer and drive into shop.

Also free from same 1991 FJ80,
Unopened A440 auto trans, cooling lines, kickdown cable, shifter, etc.

This crap will go to recycling next week.

 

[itbrokeagain]

What kind of shape was the trans in?

 

[FJ40Jim]

I only drove it on & off my trailer, but it seemed fine.
PO was DD-ing the vehicle when belt fell off WP on highway, leading to sudden, severe engine overheat.
Allegedly the drivetrain is solid.

Note that I'm keeping the T-case & shifter, necessary to re-power the truck.

 

[itbrokeagain]

I would like the transmission. The only issue is I'm in Cincinnati. If it's not in your way I will get up there. Any chance you have a small block adaptor kit to go to that transmission?

 

[FJ40Jim]

I'll hang onto tranny for a while.

Might be able to mud-ship to Cincy area for gas & beer money.

 

[itbrokeagain]

I'll hang onto tranny for a while.

Might be able to mud-ship to Cincy area for gas & beer money.

I will get up to you hopefully sometime soon. Or we can make something work out.

 

[FJ40Jim]

I'll also have a 91 FJ80 rear axle assembly up for grabs soon. If you're into that sort of semi-floater action.

 

[FJ40Jim]

Pictures of free junk from 1991 FJ80. Get it out of my driveway before it goes to scrap.

3FE short block. Was running, but should be considered rebuildable core with 250k miles & poor maintenance history.

A440 auto tranny. Fluid was full & red, reportedly worked fine. I only drove on & off trailer.

 

[94SRUNNER]

I’ve got some 1FZ items that need to go to a new home.

Complete 1FZ top end - SOLD


1FZ alternator that tested good at Dayton Quality Starter - $40

80 Series steering gear box - SOLD


80 Series front driveshaft. Needs a rebuild - $25

PM for additional details and pictures.

 

[itbrokeagain]

Pictures of free junk from 1991 FJ80. Get it out of my driveway before it goes to scrap.

3FE short block. Was running, but should be considered rebuildable core with 250k miles & poor maintenance history.

A440 auto tranny. Fluid was full & red, reportedly worked fine. I only drove on & off trailer.

View attachment 2503032

View attachment 2503033

View attachment 2503034

View attachment 2503035

Waiting to get the transmission back in my excursion. The 2 year old very expensive torque converter decided to come apart. I will be up for that transmission

 

[itbrokeagain]

Looking for a rear drive shaft out-of an 80. Going in a 92 if that matters

 

[FJ40Jim]

Waiting to get the transmission back in my excursion. The 2 year old very expensive torque converter decided to come apart. I will be up for that transmission

Yes, come get it. I just logged to say "this monster is going on the scrap trailer!"
It can sit outside a little longer if you're still needing it.

 

[FJ40Jim]

I’ve got some 1FZ items that need to go to a new home.
1FZ alternator that tested good at Dayton Quality Starter - $75

FYI, remans are less than $80.
Not trying to bust on you, just sayin' that may mean you're keeping this one.

 

[94SRUNNER]

FYI, remans are less than $80.
Not trying to bust on you, just sayin' that may mean you're keeping this one.

@FJ40Jim thank you! I only did a quick search for a price range and to be honest didn’t even price check reman’s.

Noted and adjusted

 

[FJ40Jim]

Waiting to get the transmission back in my excursion. The 2 year old very expensive torque converter decided to come apart. I will be up for that transmission

This tranny is edging closer to the scrap trailer.
Just sayin'

 

[itbrokeagain]

This tranny is edging closer to the scrap trailer.
Just sayin'

I want it. Honestly forgot about it. I will make a trip soon

 

[FJ40Jim]

Not a cruiser part, but vintage cool machinery for sale:
1962 Jacuzzi V-twin single stage compressor pump, runs fine. Was just taken out of service & replaced with a 2stage pump to feed a hungry air tool that needs 150+ psi.

Asking $100? Or equivalent amounts of root beer & cookies.