so. i’ve been studying up (with a lot of help) and pinching pennies so - does anyone mind helping me with the next steps on this 3” lift of mine?
it’s the dobinson C59-167 (front; supposedly 45mm lift/1.75”) C59-166 (front; supposedly 60mm/2.35” lift and 2 - 2.5 degree caster adjustment).
center of wheel to underside of wheel well is basically 22 1/2 rear (2 1/2”) and 23” front (3”).
i’m looking at rear panhard adjustment but right now need to settle on a caster adjustment.
i currently have six new OEM rubber bushings so i guess i am looking at caster plates and/or radius arm mounts?
i’d love to have reports from anyone that has done this especially if you did the work yourself.
also interested in what to do about the stinkbug.
THANKS
RAM mounts (any good reason to split the difference with 2” plates and RAM mounts)? FJ80 / FZJ80 RAM
it’s the dobinson C59-167 (front; supposedly 45mm lift/1.75”) C59-166 (front; supposedly 60mm/2.35” lift and 2 - 2.5 degree caster adjustment).
center of wheel to underside of wheel well is basically 22 1/2 rear (2 1/2”) and 23” front (3”).
i’m looking at rear panhard adjustment but right now need to settle on a caster adjustment.
i currently have six new OEM rubber bushings so i guess i am looking at caster plates and/or radius arm mounts?
i’d love to have reports from anyone that has done this especially if you did the work yourself.
also interested in what to do about the stinkbug.
THANKS
RAM mounts (any good reason to split the difference with 2” plates and RAM mounts)? FJ80 / FZJ80 RAM