I am in the process of putting the 3FE into my 82 land cruiser. The wiring harness that I have was cut in two places. The first is at the plug right behind the fuse box that runs to the back of the rig and also cut right at the back of the rear door on the drivers side. I was trying to find an easy solution to both of these issues but have not had any luck. Hopefully someone out there has some sort of an idea. the one in the rear is a total of 23 wires. I was thinking 23 butt connectors would be too much bulk and just connecting them by twisting with heat shrink, I figured would cause a bad ground down the road. I don't know if I have the room for a 23 pin connector but maybe I do. I just want to hear of some ideas people may have out there.