Hello fellow forum friends!
I have started the process of installing a Painless wiring harness on my 1972 FJ40. The PO I purchased from had some electrical issues that burned several areas of the harness but I’m fortunate that they left the entire OEM harness in tact.
I’ll preface my question by saying that I have done some extensive searches using the search function as well as looked through a number of posts and info by Coolerman and can’t seem to find what I’m looking for.
Is there any document or diagram available that identifies specifically what each wire is responsible for on a 1972 FJ40.
For example if I am trying to splice the original turn signal switch into the new harness: is there a digram that shows “Red/White wire = Left Blinker”
“Green/Blk wire = flasher”
Also- is the high/low beam switch for a 72 integrated into the turn signal cam? There is no dimmer switch on the floor and the turn signal cam seems to have a forward and backward motion that could be like “clicking the high/low beams”
Thank you!
Brandon
I have started the process of installing a Painless wiring harness on my 1972 FJ40. The PO I purchased from had some electrical issues that burned several areas of the harness but I’m fortunate that they left the entire OEM harness in tact.
I’ll preface my question by saying that I have done some extensive searches using the search function as well as looked through a number of posts and info by Coolerman and can’t seem to find what I’m looking for.
Is there any document or diagram available that identifies specifically what each wire is responsible for on a 1972 FJ40.
For example if I am trying to splice the original turn signal switch into the new harness: is there a digram that shows “Red/White wire = Left Blinker”
“Green/Blk wire = flasher”
Also- is the high/low beam switch for a 72 integrated into the turn signal cam? There is no dimmer switch on the floor and the turn signal cam seems to have a forward and backward motion that could be like “clicking the high/low beams”
Thank you!
Brandon