Hello and Happy New Year Everyone,
I installed new Old Man Emu torsion bars back in April and got an alignment, and a few months after I switched over, I noticed the left side was sagging about an inch lower than the right, so I went and got it realigned. About a week later the left side was back down an inch again. The bolt and nut for adjusting the torsion bar seemed a bit tired when doing the work, but since the torsion bars are brand new, I don't think the bars themselves are the culprit.
Any ideas as to what could be causing the left side to sag lower than the right? Could it possibly be the threads on the Bolt (90101-18010) and Nut (48169B) are slipping and those parts need replacing?
Thanks,
Tom
I installed new Old Man Emu torsion bars back in April and got an alignment, and a few months after I switched over, I noticed the left side was sagging about an inch lower than the right, so I went and got it realigned. About a week later the left side was back down an inch again. The bolt and nut for adjusting the torsion bar seemed a bit tired when doing the work, but since the torsion bars are brand new, I don't think the bars themselves are the culprit.
Any ideas as to what could be causing the left side to sag lower than the right? Could it possibly be the threads on the Bolt (90101-18010) and Nut (48169B) are slipping and those parts need replacing?
Thanks,
Tom