Also just finished the same job. I used a brass drift to hammer the studs out. Came out more easily than expected, but I did not have much corrosion
What did you do on your 70 series today?
- Thread starter IH8MUD
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Removed the 14mm bolts, added some heat, popped the studs out and it came apart without much fight.
Changed the bulb in the ac control, that little guy is a real son of a gun to get to
holy crap is THAT how mines supposed to look... wow puuuurdy
@joekatana Out of interest, what size tyres are those?
Finished the water system. Almost done with the air system. Low pressure regulator to the water tank. Hydronic system for hot water and air is done. Now working on the bench-bed. I used telescopic stainless tubes to extend. Probably latch with magnets.
Once the bench is done, I’ll have the cushions done with 18oz cotton canvas gray including the back rest that will be used on the bench-bed extension.
Once the bench is done, I’ll have the cushions done with 18oz cotton canvas gray including the back rest that will be used on the bench-bed extension.
Amazing V12 Swapped 78 Prado with extremely high quality build and attention to detail
Snaps from 12,000 kms December & January Aussie Roadtrip.....Sydney-Gold Coast-Cooktown-Birdsville Track-Flinder Range-Kangaroo Island- Adelaide....
Fantastic
im getting a bit of "local crime syndicate" here....
How showing cool project car has anything to do with crime?
the ridiculous cash that was dropped on it....How showing cool project car has anything to do with crime?
but it was just a joke dude,
buuttt... you do get the most flak when your right over the target....
schuy2147
SILVER Star
Wrapped up the drivers side knuckle rebuild/ brake upgrade.
Rebuild kit, rotors, and loaded calipers from @cruiseroutfit.
Rebuild kit, rotors, and loaded calipers from @cruiseroutfit.
Got my new to me inclinometer installed thanks @joekatana Also replaced my Coolant temp sensor as my gauge was reading really low. Shout out to @cruisermatt for the sensor, plus a whole host of other items to be installed soon. Glad to see that resolved the issue!
Prior to the sensor replacement, the needle would barely get above the white line on the bottom… Now it functions as designed.
Prior to the sensor replacement, the needle would barely get above the white line on the bottom… Now it functions as designed.
Last edited:
Looks nice and clean! Thanks for the support.
That’s gotta be 10HP at least
