VI: Buy/Sell/Trade, In Search Of (2 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Doing some cleaning up around the house and found this stuff hiding in with the rest of our cruiser project. I figure since I don't need any of this anymore, it's time to let it go.
Everything is out of an FJ40 (except the wiper motor. That is Toyota but may be out of a 4runner, I'm not sure) and one of the diffs is out of a '70 series but is the same as a '40 series.

- The axle housing and axles are solid. One side needs new axle seals that it comes with.
- The axle also comes with a complete set of brakes/hardware, and brake drums in good condition.
- The diff needs the preload set on the pinion and you will need a new crush sleeve. The gears themselves are in good shape as are the spiders and housing.
- There are actually two diffs here but one would be just for salvage.
* note. The axle is not covered in grease. That is synthetic Redline Shockproof oil. It just looks like grease because it is blue/green.
- The rear tire mount comes with both hinges but only one hinge pin.
- The hood and windshield latches both work but need cleaning up.
- Optima battery works well. I replaced it with a commercial one I got from work when we did the diesel swap.
- Controller for a warn 8274 winch. Works but the plastic in the plug disintegrated. It comes with the female end(for in the winch) as well.
- Two tires/rims . "P225/75 R15" (You probably just want the rims unless you need a spare.)
- A new idler shaft out of a transfer case I rebuilt.
- A Safari snorkel. In perfect condition, never been used. Took it out of the box once but then changed our intake set up and it won't work anymore.
- Rear cabin heater. It's hiding behind the tires in the picture but it works very well. It just didn't work with how we set everything up.
- More to come.

-pm me. I'm open to offers. Willing to sell everything as a lot.

IMG_4079.jpg

IMG_4083.jpg
IMG_4084.jpg
IMG_4085.jpg
IMG_4086.jpg
 
Doing some cleaning up around the house and found this stuff hiding in with the rest of our cruiser project. I figure since I don't need any of this anymore, it's time to let it go.
Everything is out of an FJ40 (except the wiper motor. That is Toyota but may be out of a 4runner, I'm not sure) and one of the diffs is out of a '70 series but is the same as a '40 series.

- The axle housing and axles are solid. One side needs new axle seals that it comes with.
- The axle also comes with a complete set of brakes/hardware, and brake drums in good condition.
- The diff needs the preload set on the pinion and you will need a new crush sleeve. The gears themselves are in good shape as are the spiders and housing.
- There are actually two diffs here but one would be just for salvage.
* note. The axle is not covered in grease. That is synthetic Redline Shockproof oil. It just looks like grease because it is blue/green.
- The rear tire mount comes with both hinges but only one hinge pin.
- The hood and windshield latches both work but need cleaning up.
- Optima battery works well. I replaced it with a commercial one I got from work when we did the diesel swap.
- Controller for a warn 8274 winch. Works but the plastic in the plug disintegrated. It comes with the female end(for in the winch) as well.
- Two tires/rims . "P225/75 R15" (You probably just want the rims unless you need a spare.)
- A new idler shaft out of a transfer case I rebuilt.
- A Safari snorkel. In perfect condition, never been used. Took it out of the box once but then changed our intake set up and it won't work anymore.
- Rear cabin heater. It's hiding behind the tires in the picture but it works very well. It just didn't work with how we set everything up.
- More to come.

-pm me. I'm open to offers. Willing to sell everything as a lot.

View attachment 1710110
View attachment 1710114 View attachment 1710116 View attachment 1710120 View attachment 1710144
How much for the....
B5BCB652-A662-4F90-A394-46A2185D8029.jpeg
67E677EE-C49A-47A1-9E21-565A39FBF128.jpeg
?

40 not included... assembly required.
 
Please! Haha

It’s feeling like a pick apart around here...
View attachment 1710401

:D

Hot wrench or Plasma?

I ran into a snag and think it’s time to refill my tanks... been making due without it for 12+ years, but sometimes it’s the right tool for the job. :D


That pic sure makes me think about going Diesel again. Even though I just put in a newer (72) V8... then I remember all the reasons why I didn’t go that way. Top of the list is a minimum of 10 years before the fuel savings would cover the expense of the swap. Next is I don’t have a much left of my clutch leg...

Moment has passed.
 
Last edited:
Oxy-acetylene. It’s never too late to slow your pace down into the slow lane of life with a 3b! Clutching in traffic 2000 times in 3 kilometres does get old... but hey if I dident then I would have to go to a gym.

Side note: going to make a b/3b motor, tranny and tcase running stand out of that rusted frame.
 
Last edited:
Hey guys long time no see. I need a set of stock 80 series headlight assemblies . I got dinged on a box 1 vi for bald tires ...... so now I have to make sure everything is mint and legal. I need a set as soon as possible. Even just to borrow or rent for some cash or buy if need be. Just needs a dot stamp as I have aftermarket Japanese halo lights
 
Hey guys long time no see. I need a set of stock 80 series headlight assemblies . I got dinged on a box 1 vi for bald tires ...... so now I have to make sure everything is mint and legal. I need a set as soon as possible. Even just to borrow or rent for some cash or buy if need be. Just needs a dot stamp as I have aftermarket Japanese halo lights

@themorb had a JDM he parted when he ‘built’ a Diesel LHD...

Anyone know which mechanic are more helpful/reasonable with JDM inspections?
 
Hey I need a, working, front axle, with no leaks, out of a fj40. I'm willing to trade everything here except the snorkel and the diff(I may have sold it but if that falls through I'll throw it in) for it.

Doing some cleaning up around the house and found this stuff hiding in with the rest of our cruiser project. I figure since I don't need any of this anymore, it's time to let it go.
Everything is out of an FJ40 (except the wiper motor. That is Toyota but may be out of a 4runner, I'm not sure) and one of the diffs is out of a '70 series but is the same as a '40 series.

- The axle housing and axles are solid. One side needs new axle seals that it comes with.
- The axle also comes with a complete set of brakes/hardware, and brake drums in good condition.
- The diff needs the preload set on the pinion and you will need a new crush sleeve. The gears themselves are in good shape as are the spiders and housing.
- There are actually two diffs here but one would be just for salvage.
* note. The axle is not covered in grease. That is synthetic Redline Shockproof oil. It just looks like grease because it is blue/green.
- The rear tire mount comes with both hinges but only one hinge pin.
- The hood and windshield latches both work but need cleaning up.
- Optima battery works well. I replaced it with a commercial one I got from work when we did the diesel swap.
- Controller for a warn 8274 winch. Works but the plastic in the plug disintegrated. It comes with the female end(for in the winch) as well.
- Two tires/rims . "P225/75 R15" (You probably just want the rims unless you need a spare.)
- A new idler shaft out of a transfer case I rebuilt.
- A Safari snorkel. In perfect condition, never been used. Took it out of the box once but then changed our intake set up and it won't work anymore.
- Rear cabin heater. It's hiding behind the tires in the picture but it works very well. It just didn't work with how we set everything up.
- More to come.

-pm me. I'm open to offers. Willing to sell everything as a lot.

View attachment 1710110
View attachment 1710114 View attachment 1710116 View attachment 1710120 View attachment 1710144
 
Looking for a 13BT (or 2H???) alternator bracket for a friend. Anyone???
 
If anyone gets this, and doesn't want the fog lights let me know.
 
ISO: edic setup for 3B. early 80's. relay and motor if anyone has one that still works...
 

Users who are viewing this thread

Back
Top Bottom