Swoosh, PM sent
VI: Buy/Sell/Trade, In Search Of
- Thread starter bikersmurf
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I could use some rear 60 springs. Something with a couple inches of lift.
My lean is getting a tad intense.
I should probably do something about it before it slouches itself into the pond one evening.
My lean is getting a tad intense.
I should probably do something about it before it slouches itself into the pond one evening.
JimJ
ATOYOHOLIC
could you make your 60 into an amphibious sail boat?
You'd probably have to fix the rear quarters...
Nah, I'm waiting till I have something you desperately need, so you'll do them in trade....
GTSSportCoupe
2LTE abuser
The landcruiser boat idea reminded me of what some Russians did with their Prado LJ78. Prado raft! Complete with depth sounder and it looks like they use the rear driveshaft to turn a propeller. Check out the pictures: Toyota Land Cruiser Prado на DRIVE2.RU 
stevebradford
In the shop
I'm also looking for some 16's that'll fit without spacers, preferably steel with a bit of rust...
Sick of my squishy little 31" bfg's.
Sick of my squishy little 31" bfg's.
stevebradford
In the shop
I'm looking for a Toyota air cleaner lid with a 3 inch or greater outlet pipe possibly from a 1fz-f or 1fz-fe. The lid on the right.
stevebradford
In the shop
Out of my league.
1981 Toyota Land Cruiser BJ42
- Thread starter
- #1,032
Doesn't seem bad... but I wonder what's hiding under the 'new' paint. Seems too good a price to not have bondo.
Co worker in Saanich drove by it today, said it looks pretty nice. Funny, I get text from there and I'm in Colorado today.
SOLD.
Hey Guys,
My long awaited, back ordered intercooler arrived so my "temporary" smaller one is up for grabs. I've had it on my truck for 3 months'ish. I'd like to get $100 for it as it was $150 + shipping. Just swapped it out tonight, still very clean and all the fins are intact. Most of it was covered by the lower valance and grill... hence the larger one!
Yonaka Intercooler Type 9 18x6x2.5''
Yonaka Type 9, 2.5" in/out, core is 2.5" x 5.5" x 18", OAL 23.25"
Hey Guys,
My long awaited, back ordered intercooler arrived so my "temporary" smaller one is up for grabs. I've had it on my truck for 3 months'ish. I'd like to get $100 for it as it was $150 + shipping. Just swapped it out tonight, still very clean and all the fins are intact. Most of it was covered by the lower valance and grill... hence the larger one!
Yonaka Intercooler Type 9 18x6x2.5''
Yonaka Type 9, 2.5" in/out, core is 2.5" x 5.5" x 18", OAL 23.25"
Last edited:
I am quite interested, just gotta take the tape measure to my engine bay tomorrow.
I can bring it to the meeting and you can try wedging it in there!
Sounds good
- Thread starter
- #1,038
If I make it out, I'll bring the "Gentle Persuader"... combined with a little liquid courage, we'll make it fit for sure. 
I bought this One yesterday.
