Ya, it's about time I upgraded. I will no longer need to carry axles, Birfields, and the tools when I adventure.
UPS Delivered My Tax Refund
- Thread starter pappy
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
jstncse
Crawling over something
As cheap as those are and as tough as they are, nobody should leave home without them.
Good use of your funds
Good use of your funds
for the 40 or 4runner? I can't count spines that well
- Thread starter
- #4
For the 4Runner, though they would fit the FJ40 too with different axle shafts.
Dumpolina
SILVER Star
- Thread starter
- #6
One side in. Gawd I hate this job. Ya, I could have just slapped in the shafts and called it a day. But the OCD in me figured I might as well tear it all down and replace everything while I was in there. Side two next weekend.
One note. The directions indicated I might have clearance issues and would need to die-grind the inside of the knuckle ball. As best as I can tell I didn't on the side I did.
The thought of not having to carry axle shafts, Birfields, and the tools to change them on my Baja trip really excites me. It's less junk I need to carry, or space I can use for something else.
One note. The directions indicated I might have clearance issues and would need to die-grind the inside of the knuckle ball. As best as I can tell I didn't on the side I did.
The thought of not having to carry axle shafts, Birfields, and the tools to change them on my Baja trip really excites me. It's less junk I need to carry, or space I can use for something else.
Last edited:
if you needed to grind it, the birf wouldn't have gone in. I had to on my 40's old axles. looks good. my old set is going in Brock's truck.
