UC chat (5 Viewers)
- Thread starter Trollhole
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Southeast Overland
Get lost! Go explore!
99UZJay said:So it's like yours now...
Well played, well played... But the only problem is mine does run. Try again sucka!
Southeast Overland
Get lost! Go explore!
It does??? Nobody has seen in some time, so we were starting to wonder...
She is taking a nap in my garage.
i think u should just leave the piggy the way it is. No point in going soa if u are never gonna wheel it.
Southeast Overland
Get lost! Go explore!
LOLOLOLOL
My Pig is already SOA.
Now if I can figure out a way to work less than 80 hour weeks I 'might' get around to rebuilding the front axle...
One reason I delayed for so long is I was debating if and if what type of front locker to install. I'm pretty sure I'm going to leave the front unlocked right now to save $$$.
oh i need to rebuild my front axle also. Dreading it!!
It's not such a bad job...just greasy
Steve, at least go limited slip. I'm going to put the Auburn LS in the front of the 62 and lock the rear.
You do have PS, right?
Steve, at least go limited slip. I'm going to put the Auburn LS in the front of the 62 and lock the rear.
You do have PS, right?
Southeast Overland
Get lost! Go explore!
I do have PS. I was thinking just rebuild it now to get it back on the road and add an ARB or TJM's new Pro Locker with an axle upgrade down the road.
I know someone with some portals that he is wanting to get rid of...
Southeast Overland
Get lost! Go explore!
Word of advice on the rebuild...if it's raining, wait til later.
Southeast Overland
Get lost! Go explore!
I was there! Not gonna happen again!
dohcdelsol93
snoogans
i finished mine up in the rain.
It was the suck
It was the suck
Yeah, we were there til about 1am. I was way past being done.
- Thread starter
- #1,356
Messy job and really sucks in the rain. The year before that we had the canopy. Would have been much easier. Also I had stuff to do last year so I didn't have time nor the beer flowing to tell people what to do or help. Maybe next time we can do it when I don't have something to do. Though I've got to do the 80 axle sometime.
hope to do mine early next yr.
tiger direct had some of those hp touchpad's in today and they sold in mere minutes!!! And no i did not get one.
readin up on soa for the dent. Looks rather complicated to me. May just stay sua. We'll see after i install those add a leafs!!
Southeast Overland
Get lost! Go explore!
the gimpey one said:
Not too complicated but I suggest you stick to lift springs or add-a-leafs before worrying about SOA. Get the dent close to 100% mechanically and then go SOA.
