Trail Tailor Offerings- Racks, Sliders, Control Arms and Misc (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I'm pretty close on having these designed. I'll offer in bare and powdered.

J

Jason, I'll take 2 when you release them! Also need to get the rear extended sway bar links :)

~G
 
Aluminum bumper spindles are finished up. These are 6061 and 7075.

Hub is 3.25" x .250" and a 1.5" diameter spindle.

J

1898998
1898999
1899000
1899001
 
Jason, I'll take 2 when you release them! Also need to get the rear extended sway bar links :)

~G


G/ All,

Finished the R&D today. Need to swap out my press brake dies for the smaller ones and get the bend offset dialed in for the pinch weld area. But, they are good.

J

1900415
 
Jason, I have been trying to get in touch with you by email to purchase tow points on my 98 but haven't been successful. Can you PM me? Thanks
 
Jason, I have been trying to get in touch with you by email to purchase tow points on my 98 but haven't been successful. Can you PM me? Thanks
 
Those look like the antenna mounts to me! I’ll definitely take a pair of those.
I guess it was wishful thinking- and why I should wear my glasses
 
Are these the 100 series shock skids?


The shock guards are next on the list once I get back from WY.

I'm trying to decide if I want to add a bottle opener to the antenna mount. Problem is; while a neat feature once you open the first beer the powder coating will more than likely be ruined. I could make these out of stainless, but then the cost would almost double.

I'm only going to make one design, so multiple offerings is off the table.

J

1901128
 

Users who are viewing this thread

Back
Top Bottom