Tiny O-Ring in Carb Rebuild Kit (1 Viewer)

Joined
Nov 22, 2004
Messages
139
Anyone know what the tiny o-ring in the carb rebuild kit is for? There are 2 o-rings, 1 is for the sight glass but the other is very very small. Thought it was for the idle solenoid, but I'm not sure since it doesn't look exactly the same.
 

surfpig

The Anti-Tech
Joined
Jan 14, 2005
Messages
4,827
Location
Tagged for removal
 
 
 
I think, but I'm not sure... is it a paper/fabric o-ring? I think it goes on top of #27 in the SOR link here (second diagram). It goes on top of that "stopper" in the body of the carb, between it and the air horn assembly. One of those parts you lose when you turn the carb upside down over the lawn :eek: .
 

surfpig

The Anti-Tech
Joined
Jan 14, 2005
Messages
4,827
Location
Tagged for removal
 
 
 
Ah, I see. I don't know... I see the one I was talking about right next to it, though. Someone who knows what they're talking about will surely chime in...

nial
 
Joined
Oct 27, 2005
Messages
18
Location
Moorpark, CA
I just purchased a tiny rubber O-ring from Spector to replace the one at the end of the idle solenoid ($7.00). This is most likely what you have.
 

65swb45

Elder Statesman
Supporting Vendor
Joined
Apr 14, 2004
Messages
28,663
Location
818-953-9230
 
 
 
Yup, that's a 2F idle solenoid o-ring. Kinda important. Not hard to change after the fact, so no biggie.
 

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top Bottom