Steering Worm Bearing Puller (loan/rent/buy) (1 Viewer)

[bamelanc]

Anyone have one or similar where they’d be amicable to loaning/renting out? Pulling bushings from steering knuckle spindle from ‘78 front axle. I’d pay shipping both ways.

 

[fjwagon]

Never used one but if looks like this one it's not a bad price.

Steering Knuckle Bearing Cup/Race/Arm Remover Service Tool

Toyota Land Cruiser Replica Toyota 09606-60010 Steering Knuckle Bearing Cup/Race/Arm Remover Service Tool Made from 4140 CrMo

trail-tailor.com

 

[sggoat]

Not sure exactly what you are asking for--The steering worm is in the steering housing-output shaft goes to the drag link. If the tool is needed for the steering KNUCKLE-that's on the axle--and if you need a tool to knock out the upper/lower knuckle bearing races-a simple brass drift(~ 1/4" in diameter) will work just fine--
Pics would help--

 

[bamelanc]

Never used one but if looks like this one it's not a bad price.

Steering Knuckle Bearing Cup/Race/Arm Remover Service Tool

Toyota Land Cruiser Replica Toyota 09606-60010 Steering Knuckle Bearing Cup/Race/Arm Remover Service Tool Made from 4140 CrMo

trail-tailor.com

Thank you, but that’s to remove the knuckle bearings and knuckle bearing races. I’m pulling the brass bushings from the knuckle spindle.

09612-65010 or maybe 65012.

65012

 

[bamelanc]

I ended up using the bearing puller/slide hammer from Oreilly’s to get them out. Wasn’t the perfect tool for the job, but close enough.