Greetings all, my 94 80 series is experiencing starting issues like many of you. I've spent a lot time researching the issue and the best/most economical fix is the Painless Performance Hot Shot 30202. Product - Painless Wiring - https://www.painlessperformance.com/wc/30202
The wiring diagram and provided instructions leave much to be desired. http://www.painlessperformance.com/Manuals/30202.pdf
This post from a few years ago help quite a bit but didn't answer everything Hotshot starter relay 30202 kit for intermittent starting install ? - https://forum.ih8mud.com/threads/hotshot-starter-relay-30202-kit-for-intermittent-starting-install.995986/
Can anyone that has installed one of these help confirm where the (4) wires terminate:
Here's my girl:
The wiring diagram and provided instructions leave much to be desired. http://www.painlessperformance.com/Manuals/30202.pdf
This post from a few years ago help quite a bit but didn't answer everything Hotshot starter relay 30202 kit for intermittent starting install ? - https://forum.ih8mud.com/threads/hotshot-starter-relay-30202-kit-for-intermittent-starting-install.995986/
Can anyone that has installed one of these help confirm where the (4) wires terminate:
- heavy gauge purple connects to spade terminal on starter (replacing existing wire)
- heavy gauge red wire - doe it connect to other threaded connection on starter or is it not used at all? I've seen conflicting info
- smaller gauge purple wire - where do I tap into the starter trigger? I've read it terminates to same spade connector as heavy gauge purple wire? Again, seen conflicting info
- black wire - frame ground
Here's my girl: