SOA help

Discussion in '40- & 55-Series Tech' started by megolfer, Dec 19, 2003.

  1. megolfer

    megolfer

    Messages:
    2,295
    Likes Received:
    365
    Joined:
    Jan 29, 2003
    I am getting ready to pull my cruiser apart to do a spring over. I noticed the the PO had used a block uder the solid spring mount in the rear to lift it. Im nor sure why, but maybe to even it out because of spring sag. My question is, should I leave it and just do the spring over, or should I change it. They seem to have done a really good job, they reinforced it on the back side. Her are some pics to go along to help explain what I am talking about. Also I have not decided if I am going to do a shackle reversal yet. I am worried about getting the mounts threw the frame lined up. How hard is this and what is the best way to get it straight. Any help would really help.

    Thanks
    Cacy
     
  2. megolfer

    megolfer

    Messages:
    2,295
    Likes Received:
    365
    Joined:
    Jan 29, 2003
    another
     
  3. megolfer

    megolfer

    Messages:
    2,295
    Likes Received:
    365
    Joined:
    Jan 29, 2003
    Rear shackle
     
  4. megolfer

    megolfer

    Messages:
    2,295
    Likes Received:
    365
    Joined:
    Jan 29, 2003
    Sits pretty even
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.