I have searched and have not found anything on this. So, what is the safest way to remove the rear control arms? I am wanting to pull them to weld in some angle iron to beef them up before CM09' so they will only be off the truck for a few hours then back on again.
Any tricks to removing them and how to support the axle while they are off would be appreciated. Also, if anyone has the torque specs for the bushing bolts so I can get them back to spec when i put it all back together would be helpful.
Thanks
Zane
Any tricks to removing them and how to support the axle while they are off would be appreciated. Also, if anyone has the torque specs for the bushing bolts so I can get them back to spec when i put it all back together would be helpful.
Thanks
Zane