Vae Victus
Posting more than I know
I purchased this rear badge a while ago and it’s been sitting in my parts ready to be installed. I was measuring today to see where it should line up on the rear and noticed that the rear posts where it screws in have about 10 mm of extrusion prior to the screw posts that don’t look correct.
Is this the way it’s supposed to be set up? It does not look like when you drill through the rear quarter panel that the nuts would be able to hold it in place properly. I’m also pretty sure that you don’t allow this to stand off from the rear panel - which would make you drill quarter inch holes instead of 1/8th inch holes, roughly speaking.
Sorry for the big pictures, I’m posting from my phone and can’t adjust their size.
Is this the way it’s supposed to be set up? It does not look like when you drill through the rear quarter panel that the nuts would be able to hold it in place properly. I’m also pretty sure that you don’t allow this to stand off from the rear panel - which would make you drill quarter inch holes instead of 1/8th inch holes, roughly speaking.
Sorry for the big pictures, I’m posting from my phone and can’t adjust their size.