Question about Sliders and Exhaust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

@Will Van Front goes to the outboard and the rear manifold goes to the inside, I kept my wiring the same way, though I don’t think it would matter, also I think the wiring could only stretch so far
 
@Will Van Front goes to the outboard and the rear manifold goes to the inside, I kept my wiring the same way, though I don’t think it would matter, also I think the wiring could only stretch so far

Roger that. Thank you so much!
 
@Will Van what did you end up doing with your exhaust to fit the late style sliders?

I have a 93 fzj80 and I am wanting to go the same route except to go with a late style white knuckle slider. I want a late style slider cuz I'm want to get a later model 80 in the future so I can just switch over. I have the magnaflow 23120 waiting to be put on.
 
@Will Van what did you end up doing with your exhaust to fit the late style sliders?

I have a 93 fzj80 and I am wanting to go the same route except to go with a late style white knuckle slider. I want a late style slider cuz I'm want to get a later model 80 in the future so I can just switch over. I have the magnaflow 23120 waiting to be put on.

I used the Magnaflow downpipe and the Ottram stainless steel exhaust. I had a local fabricator weld v-band clamps to the Magnaflow and Ottram inlet. The exhaust required some finessing because the exhaust hangers are different. Then I relocated the O2 sensors to the exhaust manifolds.
 

Users who are viewing this thread

Back
Top Bottom