I just replaced my rear springs with landcruiser AHC springs (about $100 cheaper and may be firmer). Anyway, after an uneventful install, AHC now no longer works and I have code C1713 in Techstream. It won't clear either.
I tried shorting pin Tc and E1 as was described in another post, starting the engine, and reading the "Off" lights blinking pattern. It's one blink, pause, followed by three blinks, and then starts over. I pushed eeh brake pedal nine times quickly, but that didn't reset the code either. I tried this three times.
My AHC worked perfectly this morning, so I'm wondered what I could have messed up. The rear height control sensor bracket did look bent a little, so I straightened it up, but that didn't work.
Ideas?
I tried shorting pin Tc and E1 as was described in another post, starting the engine, and reading the "Off" lights blinking pattern. It's one blink, pause, followed by three blinks, and then starts over. I pushed eeh brake pedal nine times quickly, but that didn't reset the code either. I tried this three times.
My AHC worked perfectly this morning, so I'm wondered what I could have messed up. The rear height control sensor bracket did look bent a little, so I straightened it up, but that didn't work.
Ideas?