Yay !!!! Can't wait to put mine on
New F & 2F carbs (3 Viewers)
- Thread starter Trollhole
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
PayPal sent.
Sent from my iPhone using IH8MUD
Sent from my iPhone using IH8MUD
- Thread starter
- #723
Machined all the spacers yesterday . Glad to have that done. Also shipped some carbs out as well. Have a whole bunch to inspect, test, and build. More pics to come.
- Thread starter
- #724
Working on shipping the next round out.
- Thread starter
- #726
Got it thanks.
Just ordered one for my '72 F, please let me know when it ships, thanks!
Dunno if it matters, but we're @ ~300' elevation relative to sea level.
Dunno if it matters, but we're @ ~300' elevation relative to sea level.
- Thread starter
- #729
Another batch getting inspected. A lot of the f cable order are going out today.
Woo hoo! Can't wait to desmog this MFer
- Thread starter
- #733
toyofj60 said:
Idle speed screw. You shouldn't need to touch the other screws. Call me if you need and help. 864-414-0563. Marshall
Thanks
- Thread starter
- #735
I'm not exactly under standing what you are asking. Can you post any pics.
no havent been able to figure out how to post pics yet my comp sucks!! my cruiser was setup identical to trapper50 's pics in the "my demog thread".... i was talkin about the vac line that was connected to my carb on the valve cover side and went to the bvsv on the thermostat housing from there it goes to the vsv on the inner fender, which is used to control vac to the evap canister i think ...i had three vac lines to the side of the carb previously. The vac advance, the decel fuel cut , and the bvsv for evap . the other port i had capped . i took out my fuel cut vac switch when i put on the troll hole, hooked the advance line to the carb i was wondering if i could hook the one for bvsv to the thing with three nipples on it that is on my intake manifold (the manual calls it a gas filter) to receive vac
by the way i installed the carb tonight and it fired right up, i didnt get a chance to set the idle good because my power steering pump my dad jus rebuilt for me started leaking 
but it ran long enuff for me to kno its definitely an improvement. very smooth ......hopefully i will get to drive it tomorrow maybe jus maybe the new seals in the pump have swollen and it wont leak tomorrow
but it ran long enuff for me to kno its definitely an improvement. very smooth ......hopefully i will get to drive it tomorrow maybe jus maybe the new seals in the pump have swollen and it wont leak tomorrowHey Marshall, didn't you mention that something new was coming in on this shipment? Are you ready to reveal what that is or provide some hints?
My carb should be here Thursday. I ordered the idler pulley, cap & plug & EGR blockoff from Jim C. today. Looking forward to getting all that failing smog crap off & getting my FJ60 running good again!