Need to find aftermarket gas tank filler neck inlet?

[1973Guppie]

Having trouble finding a decent aftermarket gas tank filler neck flange inlet. This is for my fj40 on the rear auxilary tank. Right now I have diamond plating back there and am using an old confer filler neck I found used awhile back. I would like to find something that has 2 ports, one for vent and one for fill. I can't seem to find anything out there? Can somebody point me in the right direction. Round in black with a flat mounting surface would be perfect. I am thinking of using a jeep fill neck from a newer tj.

Noah

 

[bigassbike]

Would this work?
Item number: 260343692998

 

[1973Guppie]

thanks but I think that will have to be welded flush with the rear sheetmetal, correct? I am looking for something that will simply bolt in place after cutting a large enough hole and have a flange that can sit on top of the sheetmetal, a bit easier and less expensive to get done.

Noah

 

[bigassbike]

Wasn't sure if it would work for ya but I was surfing ebay and saw it. (Not my auction.) Probably too much $ for the amount of work it would take.

thanks but I think that will have to be welded flush with the rear sheetmetal, correct? I am looking for something that will simply bolt in place after cutting a large enough hole and have a flange that can sit on top of the sheetmetal, a bit easier and less expensive to get done.

Noah

 

[1973Guppie]

looks like maybe a full filler assembly from an 03-06 tj might work?

 

[inkpot]

Howdy! How about the filler neck for an 85-ish mini truck? I have the one out of my trailer/bed spare. It only drops a little bit, but it does have the vent line built in. It's about 8" long, and then it has about 18" of flex line. John

 

[fieldsken1]

go to jaz products they have what you are asking for