Pathfinder
I am the STIG
I have a fj60 where the right rear quater panel needs replacing from where the PO backed into something stronger than my cruiser. I have a replacement quater panel that I purchased of of a used cruiser. in addition to that I would like to get new steel welded in where the typical cruiser rust is coming through on the wheel wells.
Any reccomendations on where / who can do good job of getting the body panels cut in at a decent price?
I am located in the Daytona Beach, FL area but can drive to Orlando and or Jacksonville. Thanks
I posted in the paint and body section however have not heard anything there. Though someone might have an idea. This is a project that I would like to tackel on my own however I fear that all I would end up doing is screwing up a donor panel and be no better off than when i started. Thus why I am looking for a pro.
Here is a shot of the right rear section plus donor panel.
Any reccomendations on where / who can do good job of getting the body panels cut in at a decent price?
I am located in the Daytona Beach, FL area but can drive to Orlando and or Jacksonville. Thanks
I posted in the paint and body section however have not heard anything there. Though someone might have an idea. This is a project that I would like to tackel on my own however I fear that all I would end up doing is screwing up a donor panel and be no better off than when i started. Thus why I am looking for a pro.
Here is a shot of the right rear section plus donor panel.
Last edited: