Who can guess what these three holes are with screws in them? I may have a small prize to the winner if it isn't too obvious.
Jeremy
Jeremy
Mystery holes, who can guess?
- Thread starter BELMONT148
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
ClemsonCruiser
Supporting Vendor
my guess would be some sort of aftermarket antenna or telescoping mirror
Last edited:
Aussie mirror mount?
(JP, it's way past your bedtime!)
(JP, it's way past your bedtime!)
Turn signal switch since your missing your.
Brake light
Satellite radio
Area for new missing bottom hinge
bolt holders for top wind shied hinge
spare tire carrier
next location for more jeep parts
an area that is sealed, unlike your tranny hump
new air vents
a smaller version of my shower install
snorkel mount
mounting holes for the new UC emblem you made and are giving out to every member.
Ash tray
Booster cables holder Just for Richard
Brake fluid holder for Chuck
Mounting holes for a Clemson suxs emblem.
Another area to add more key switches that don't do anything.
A place to store the rest of your steering column.
New mounting hole for your missing lap belt.
Last edited:
- Thread starter
- #5
Wrong Marshall, it's a place to store my missing tranny boot. How could you miss that, looks like you went through that picture with a magnifying glass.
I just put this up for jokes. I was so happy when I figured out what they were for, that I had to share. I have been staring at those screws for 2 1/2 years, and just realized it was where they installed late model 40 series mirrors. They are filled now with metal. That was just too hokey for me to leave.
Jeremy
I just put this up for jokes. I was so happy when I figured out what they were for, that I had to share. I have been staring at those screws for 2 1/2 years, and just realized it was where they installed late model 40 series mirrors. They are filled now with metal. That was just too hokey for me to leave.
Jeremy
- Thread starter
- #6
By the way, I do have a turn signal switch. It is the stock one. I modified it to fit on a later column, since you can't wire a newer switch into an older style harness. The rear lights are wired different. I wanted a newer column for my sag. steering, and a newer wheel, but wanted to keep the old turn switch.
The tranny hump will be sealed after paint, and I have a new carpet set going over the floor.
No lab belt missing, that a 5 point harness.
And Clemson doesn't suck!
I also just got a set of leather Volvo seats right in your neck of the woods. They are power adjustable in dark grey. Paid $100 for them in Simpsonville.
Jeremy
The tranny hump will be sealed after paint, and I have a new carpet set going over the floor.
No lab belt missing, that a 5 point harness.
And Clemson doesn't suck!
I also just got a set of leather Volvo seats right in your neck of the woods. They are power adjustable in dark grey. Paid $100 for them in Simpsonville.
Jeremy
Last edited by a moderator:
So, what do I win?
Cash is always good
Cash is always good
ClemsonCruiser
Supporting Vendor
now david I beat you buy 3 minutes.........
younger and faster! The victory is yours Red Baron.
ClemsonCruiser
Supporting Vendor
I tell you what we can split the reward...... because I did throw up two answers; instead of being brave enough to go with one
alright jeremy how much is it $100........ $200
- Thread starter
- #11
Well, I don't think either of you got it right. Telescoping mirrors are mounted on the windshield and have two hole side by side.
Aussie mirrors are usually mounted on the fenders since they are RHD.
But the reward was going to be a Landcruiser sticker. I guess I can send one of the you the Land part and the other the cruiser part. Just let me know who gets what.
Jeremy
Aussie mirrors are usually mounted on the fenders since they are RHD.
But the reward was going to be a Landcruiser sticker. I guess I can send one of the you the Land part and the other the cruiser part. Just let me know who gets what.
Jeremy
I'll be seeing you in a couple weeks. I'll pick up the Clemson sucks sticker for them then. Ok?
By the way, I do have a turn signal switch. It is the stock one. I modified it to fit on a later column, since you can't wire a newer switch into an older style harness. The rear lights are wired different. I wanted a newer column for my sag. steering, and a newer wheel, but wanted to keep the old turn switch.
The tranny hump will be sealed after paint, and I have a new carpet set going over the floor.
No lab belt missing, that a 5 point harness.
And Clemson doesn't suck!
I also just got a set of leather Volvo seats right in your neck of the woods. They are power adjustable in dark grey. Paid $100 for them in Simpsonville.
Jeremy
All in good fun. Where is that harness I see none?
Got any pics of what that mirror looked like? Just curious.
- Thread starter
- #14
There
Just send the whole sticker to JP. He can use it to hold down his valve cover in lieu of bolts, which are small and bothersome.
