- Thread starter
- #41
Thanks to Alan, Marshall, Alex, JP, Gehn, and David for comin out to the Chateau to work on the blue beast. I think we all found out that no matter how much preperation you do there is always something that is gonna slow ya down. The Tcase came to a hault when we took a closer look at the bearings and found out they were a little too gone to put back in. The bell housing was another long process of switching those out, but with diligence and persistance we got that done along with a new rear main seal and pilot bearing. The axle looks almost brand new after the crew cleaned it all up...you could eat off of that thing once I put a coat of pain on there....gotta smooth out one of the insides of the knuckles and it''ll be ready to put back together. And Marshall helped me put in my new water heater..nice to take a shower again. Plus the dreary ass weather didn't help any...but I believe that all of the prep work has been done, once I get new bearings for the tcase it'll go together in about 5 minutes and hook it back to the tranny and in it'll go into the bellhousing. Then rebuild the axle and it'll be able to rock and roll. It is true the prep always takes the longest. But thanks to all of you guys...we put in a lot of hard work and thanks for all of the tools..made it a lot easier. Thanks, Chuck