Maintenance Question (3 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 11, 2018
Threads
6
Messages
18
Location
VA
I know I am taking a chance on getting ridiculed but I am hoping I can get some guidance. Just purchased a '23 GX460 with 24K miles. My question is regarding the gear oil and transfer case oil. I have decided to use 5W-30 in the engine. I know what the manual says for the gear and transfer case oil but what do you use? I want to protect my "investment" and don't care about fuel economy (if I did, I sure would not have purchased a V8). It seems some use 75W-90 for all three boxes. Some use Red Line for the transfer case. Anyways, I'd like your opinion. Oh, I did get that small filter to replace the foam one on the secondary air box. Any advice, I'm all eyes and ears.
 
Likely to hear full spectrum of recommendations

I wouldn't think the 5W-30 would cause any issues.. IIRC...others have previously posted an option in other markets.

I do 0W-20 Amsoil on mine. I also use Amsoil gear oil for the front and rear diff..but the OEM 75W unicorn piss in the center diff. :-)

I haven't used it myself but Revenol has a straight 75W for far cheaper than OEM

 
I just did a full fluid replacement at 45k miles. Toyota coolant, trans fluid, and gear oil for the transfer case. F/R diffs, used redline. Similar logic to protect my Nori.
 
I know I am taking a chance on getting ridiculed but I am hoping I can get some guidance. Just purchased a '23 GX460 with 24K miles. My question is regarding the gear oil and transfer case oil. I have decided to use 5W-30 in the engine. I know what the manual says for the gear and transfer case oil but what do you use? I want to protect my "investment" and don't care about fuel economy (if I did, I sure would not have purchased a V8). It seems some use 75W-90 for all three boxes. Some use Red Line for the transfer case. Anyways, I'd like your opinion. Oh, I did get that small filter to replace the foam one on the secondary air box. Any advice, I'm all eyes and ears.
What weights are you using ?
 
I have the dealer do it, and use that as an opportunity to get a second set of eyes on my chassis.

I use recommended weight. If it was a steel block I would probably run 10w30
 

Users who are viewing this thread

Back
Top Bottom