Got my HEI swapped in, and it runs! Good thing, because I don't know how to use a timing light. I just noted where the toy dizzy's rotor was pointing, and put the hei in that way. I had to adjust it by ear a bit, but it seems fine.
I wired it up using a 30 amp relay(thanks Ed Long!). I get a good juicy 12.76 volts going to the dizzy.
I got some custom wires, and cut them to length.
I basically rebuilt the distributor, with new weights and a crane cams advance kit.
I don't know what I'm gonna do with the heater pipe that I unbolted from the block. Other than that, it's excellent.
Thanks to everyone who helped this d.a.n. out with all this
I wired it up using a 30 amp relay(thanks Ed Long!). I get a good juicy 12.76 volts going to the dizzy.
I got some custom wires, and cut them to length.
I basically rebuilt the distributor, with new weights and a crane cams advance kit.
I don't know what I'm gonna do with the heater pipe that I unbolted from the block. Other than that, it's excellent.
Thanks to everyone who helped this d.a.n. out with all this