- Thread starter
- #41
Err, rookie mistake as far as the bench bleed goes. I had too long of tube back into the reservoir and tube was not below fluid level. M/C works good now, nice to see as all these cylinders fire as they were nasty. I notice fluid leaking out of one wheel cylinders. I'll need to replace that cup 1-1/8" front, Dorman makes one #2936 available at NAPA.
I ended up using the piston on the right in photo, from SOR, it was 2mm shorter than the original. Center in photo is original I pulled out. Left is the JBS clutch piston - - ironically it is the same length as original.
I ended up using the piston on the right in photo, from SOR, it was 2mm shorter than the original. Center in photo is original I pulled out. Left is the JBS clutch piston - - ironically it is the same length as original.