Hey yall! So I just got a 1990 Land Cruiser Prado EX5. Just over 100k miles on it. I have absolutely loved it so far.
Here’s where I need some help, I think I saw a thread about this, but can’t find it now so if anyone knows where that’s at then just send me that direction… But I was driving the other day and my truck died. I believe it was my ECD main relay that went bad. I have tested it and the coil is fried. I put the two power wires on a switch until I can get a new relay, but when the truck starts it stays at about 2k rpms, no throttle response, running real rough and check engine light Is on. Can anyone help me out or tell me what’s going on? I would really really appreciate it!
Thank you!
Here’s where I need some help, I think I saw a thread about this, but can’t find it now so if anyone knows where that’s at then just send me that direction… But I was driving the other day and my truck died. I believe it was my ECD main relay that went bad. I have tested it and the coil is fried. I put the two power wires on a switch until I can get a new relay, but when the truck starts it stays at about 2k rpms, no throttle response, running real rough and check engine light Is on. Can anyone help me out or tell me what’s going on? I would really really appreciate it!
Thank you!
