no, the broken guide I saw was the one with 3 bearings. Only aluminum though and the head broke off the shank probably due to the blade snagging the part or the table. It was held with 2 screws like yours I think.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
SMG, they (the green ones) used to come with a table like that. It mounted directly on the blade guide. And I've seen one guide broken because of it.
I don't know if this is really very helpful or not, but here's a little video I did when I was dissecting my ex-cylinder head. Shows the spring compressor I made and how to do it. Pretty easy really.
Many YouTube videos showing a lot of cool mods to be made to this saw. Auto drip lubing, chip pan collector, many vise mods including small part holding, air and hydraulic cut control...
SMG,
Really good work!
I need something similar for the rods I use with my old school torch: fillers and brazing rod.