High pinion locker into 9.5 axle?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 26, 2004
Threads
46
Messages
292
Location
South western alps south east part of France. Righ
Hi everybody!

Well, as it seems, i can get a cheap electric locker from a HZJ78, that is a high pinion 8in 4.3/1 locker. Any idea if it would fit the 9.5 inch housing and still be centered? Is the spline count the same? I've just missed a HDJ 80 rear axle with locker for 350 euros!

Best regards.

Max.
 
The front spline count is the same, and with some minor mods, it can fit into a Hilux front axle housing. If you really want to use this differential in your 60, you can get a custom width Hilux housing made at FROR Fab and it can work in your 60.

Another hurdle is the 4.3 ratio. No R&P sets available for the standard cruiser rear diff, so these will have to be swapped to 4.1 or 4.56. 100 series R&P would be tricky to fit into the older style diff.

Dave
 
curious why you say this, i have both sitting here and i compared the housing size of the 2000 HZJ79 and the 95 PZJ75 and they are the same...
one is 4.56 and the other is 4.30...
maybe you know something i don't...care to share?
 
caliper_comparo.jpg

DCP_1915.jpg

70axle_housing.jpg

site1026.jpg

CV_joints.gif

picked three of these up off an Oz site, not sure about the others.[filing system ,,what???] :cheers:
 
Dave, cheers mate , were the other two posted by you? :whoops: Was wondering where they came from. Earlier I was thinking of swaping motors to a 1HZ so started saving info,seems it is a lot easier to change trucks not much to save by swaping motors. :idea: You guys know the story on that from 1HZ + turbo post +bearings. :cool: Hey blokes, lets have a few more PICTURES. :cheers:
 
No worries, Gazza :cheers: Once I post a picture on the internet, it is public property :) I have to give credit to Dave who took the third picture.

Dave
 

Users who are viewing this thread

Back
Top Bottom