I am getting closer to the finish line on my frame-off. I have a wire with a bullet connector on the switch side of my turn signal/dimmer switch. It is green/white. There is no connector on the harness side and it's been over a year since I removed it, so I don't remember if it was connected to anything. It does not have wear marks ans is completely tarnished as if it were not connected anytime recently.
A total of 10 wires come from the switch. 3 for the dimmer and 7 for the turn signals. Per one schematic, the G/W wire connects to the brake light wire after the brake switch for a combo light. Another schematic shows a 7th wire from the turn signal switch not used and none of the other wires are G/W.
My taillight assemblies are the separate turn and brake lamps, not a combo lamp. I am assuming it is unused. But we all know what assuming get us.
A total of 10 wires come from the switch. 3 for the dimmer and 7 for the turn signals. Per one schematic, the G/W wire connects to the brake light wire after the brake switch for a combo light. Another schematic shows a 7th wire from the turn signal switch not used and none of the other wires are G/W.
My taillight assemblies are the separate turn and brake lamps, not a combo lamp. I am assuming it is unused. But we all know what assuming get us.
Last edited: