Hard Door Window Glass Replacement and Vent Window Question

[firemanj92]

What is the proper order of the hardware that mounts on the bottom pivot? I have the spring, washers, plastic washer, and metal piece but I'm not sure what order they go in for re-assembly. Thanks.

plastic washer is above larger washer...hope this helps. Now if I can just find where those hole cover/door plugs 67556-60010 went.

 

[Green Bean]

View attachment 2728199
plastic washer is above larger washer...hope this helps. Now if I can just find where those hole cover/door plugs 67556-60010 went.

 

[Green Bean]

Perfect. I sure appreciate it. There is a little metal do-hickey that fits over the spindle. Where does it go and does it matter which way the pointed part faces? By the way, if you can't find your plugs, I bought a pair from SOR.

 

[firemanj92]

Perfect. I sure appreciate it. There is a little metal do-hickey that fits over the spindle. Where does it go and does it matter which way the pointed part faces? By the way, if you can't find your plugs, I bought a pair from SOR.

I bought the plugs from Sor also, but I can't seem to find my OEM plugs either. The metal c-shaped points up the lock nuts tension the spring against it and the underside of the door sill. The pic is oriented upright.

 

[73FJ40]

I bought the plugs from Sor also, but I can't seem to find my OEM plugs either. The metal c-shaped points up the lock nuts tension the spring against it and the underside of the door sill. The pic is oriented upright.

@Green Bean

 

[Green Bean]

@Green Bean

View attachment 2728519

That is absolutely fantastic. This is what is wonderful about this forum. Hopefully, in the future someone else will benefit from your photograph of the order of assembly. Thank you again!

 

[MtnAddict]

Reviving an old great thread. Before I make a mess, is it possible to remove the wing window and install new gasket without taking the door apart?

 

[wngrog]

Reviving an old great thread. Before I make a mess, is it possible to remove the wing window and install new gasket without taking the door apart?

I don’t see how.

 

[MtnAddict]

I don’t see how.

I figured, just thought I would ask. Thanks.

 

[wngrog]

Reviving an old great thread. Before I make a mess, is it possible to remove the wing window and install new gasket without taking the door apart?

Looking back on this thread it actually looks like I got it out before I broke the glass and had to take the door apart.

Been so long. All I’ve done since I had the door off the truck