GX460 Goose Gear Rear Plate Underside (1 Viewer)

[ovrlndyg]

Quick question for those who have the Goose Gear Rear Plate:

Lexus GX460 2010-Present 2nd Gen. Rear Plate System™

With the GX460 Plate System™ you can now easily install and remove Goose Gear Modules with simple hand tools. This system requires the removal of the third row seat and carpet kit. Does not require cutting or drilling of any part of the vehicle. Once the plate is installed you now have a clean...

www.goose-gear.com

I wanted to find out if there is any space under the board to route wires. I know there is a cross beam on the floor, somewhere in the middle. I was wondering if there is any gap between that and the plate. I might want to run some wiring from the front (closer to the second row) and then go under the plate and to the back of the vehicle. It wasn't clear whether there were any gaps to do that.

 

[re_guderian]

Does this help? Do you have powered 3rd row seats?

3rd Row Seats Power Tap without cutting or splicing OE harness

Hello Folks, I have found a way to harness the 2 3rd row seats power circuits that are fused at 30A directly from the battery and always on without messing with OE harness. The OE wiring are not really rated for 30A but it can be safely used for around 20A of constant use and a spike within...

forum.ih8mud.com

 

[BigSwede]

Not entirely sure, but I would think so. There is a spacer under the plate in the middle.

Or just run the wires under the plastic trim along the side.

 

[OCGX]

Yes, there should be enough room to run some wires.

Here is the GX460 Floor (Not my pic).

This video is helpful and he shows the spacers under the Goose Gear