Apologies in advance. I searched but could not find a clear answer. When rebuilding or resealing a transfer case, is it recommended or required to coat the output shaft bearings and the idler shaft bearings in grease?
I had to rush through my t case reseal. it had been about 8 years since I did it last. I only very lightly coated the idler shaft and bearings in grease. And I only very lightly coated the output shaft races in grease on the inside. When I say lightly, I mean a very very small amount..
After putting it all back together and driving it, I remember using a lot more grease on the shafts and bearings previously.
Thanks
-Bryan
I had to rush through my t case reseal. it had been about 8 years since I did it last. I only very lightly coated the idler shaft and bearings in grease. And I only very lightly coated the output shaft races in grease on the inside. When I say lightly, I mean a very very small amount..
After putting it all back together and driving it, I remember using a lot more grease on the shafts and bearings previously.
Thanks
-Bryan