Parting Out Gone to scrap yard: 1987 FJ60, Conway, AR, United States of America

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Bama4door said:
@cyberfalco hey do you have the clutch pedal bucket, front/rear dshafts or trans crossmember? I will be coming up to Conway in the next couple weeks.
Click to expand...
I still have the complete pedal assembly but none of the other items.
 
@cyberfalco Ok I'll take the pedal assembly. Do you have the clutch slave and master cylinders or the clutch lines, transmission tunnel cover, or 2f flywheel and bolts? Sorry for the long list, I'm doing a 4spd swap into my 62.

Do you mind holding everything for a couple weeks until I get up to Conway?
 
Bama4door said:
@cyberfalco Ok I'll take the pedal assembly. Do you have the clutch slave and master cylinders or the clutch lines, transmission tunnel cover, or 2f flywheel and bolts? Sorry for the long list, I'm doing a 4spd swap into my 62.

Do you mind holding everything for a couple weeks until I get up to Conway?
Click to expand...

I have the clutch slave and master all still connected to each other. I just unbolted the slave from the bell housing when I pulled the motor. Trans tunnel cover, flywheel, and flywheel bolts were sold already.

I will hold onto them.
 
cyberfalco said:
For Sale: - 1987 Toyota Land Cruiser FJ60, 129,285.4 miles, $2500, Arkansas, USA

Above is the orignal post for the whole vehicle. Since I have not had any takers I have decided to part it out. Small items I will ship at your cost. Shipping for larger items will be the buyers responsibility as I have no way to ship large items.

Warn 8274 - $800, I cannot ship this.
Click to expand...

Hey man im looking for an igniter and coil in good working condition. please let me know if you sill have one.
 
I am interested in the steering intermediate shaft (The small section from the firewall to the steering box).

Please PM me with a price shipped to 93065.

Thanks

Dyno
 
Dynosoar said:
I am interested in the steering intermediate shaft (The small section from the firewall to the steering box).

Please PM me with a price shipped to 93065.

Thanks

Dyno
Click to expand...
I will check it out after work tomorrow to make sure it's good and send you a message with a pic
 
Dynosoar said:
I am interested in the steering intermediate shaft (The small section from the firewall to the steering box).

Please PM me with a price shipped to 93065.

Thanks

Dyno
Click to expand...

Sorry, I have been quite busy at work but I finally have a free weekend. I will be pulling the car up onto a trailer so I can remove the axles and I will get you a pic of that shaft.
 
I will be pulling this car up onto a trailer for final scavenging of the body and frame this weekend. I will then open a new thread with all of the good parts I have pulled. Feel free to send your questions as I finally have a free weekend to finish removing everything.
 
cyberfalco said:
I will be pulling this car up onto a trailer for final scavenging of the body and frame this weekend. I will then open a new thread with all of the good parts I have pulled. Feel free to send your questions as I finally have a free weekend to finish removing everything.
Click to expand...
 
Lower tailgate, no rust through, license plate light assembly is damaged. $200 plus shipping. Shipping is roughly $160 via Fastenal.
29056274481_d05ebd3a6a_c.jpg

28846371420_0a98b3c4db_c.jpg
 
H42F transmission, top cover, shifter, 129K miles $160 plus shipping
Bell housing with starter $30 plus shipping
Inspection cover $10 plus shipping
Clutch fork with used throwout bearing $10 plus shipping
28514619003_88dd8a012b_c.jpg

28511541144_34ae9e0843_h.jpg
 
You must log in or register to reply here.

Share this page

Back
Top Bottom