Had time to take my driveshaft to the local driveshaft shop. Pretty cool that as i walked in, there was a cruiserhead that i had wheeled with in Daton several years ago. Anyways, back on track. . . so the shop owner came out and rolled under my truck, measured the distance from my output flange on the diff to the output flange on my center diff. Then he measured my drive shaft length while it was fully compressed. Then he said "well, your problem is that you are driving around on a fully compressed drive shaft" He said he will shorten my driveshaft by 1 inch, balance it and then it should be fine. So, i'll let you know when i go and pick it up and put it in if that was the fix.
I was trying to figure out what would cause this distance to shorten?
I was trying to figure out what would cause this distance to shorten?