While doing a simple oil seal replacement on the front right I discovered this:
I am able to put it back into it’s proper place but fit is loose which is no good.
My initial inclination was toward mangling it enough to remove it through the end of the housing but I think that, without it, axle shaft installation would wreak havoc on the integrity of the oil seal. How important is this part? Has anyone reseated it with success?
My initial inclination was toward mangling it enough to remove it through the end of the housing but I think that, without it, axle shaft installation would wreak havoc on the integrity of the oil seal. How important is this part? Has anyone reseated it with success?