Hi All,
I removed the water pump last weekend - what a struggle that was!
I'm going to reinstall the new AISIN one I bought from @Racer65 this weekend, but it got me thinking. When I removed the waterpump I ended up following a thread here that said to pull the studs.
Per cityracer's instructions, I will apply FIPG to both sides of the gasket for the water pump. I feel it will get really messy if I try to hold the water pump and gasket covered in FIPG while I try to put studs through the holes. Then on top of that, I've got to tighten everything down before the gasket sets.
Has anyone run into this issue?
Is there a more straightforward way?
Thanks!
I removed the water pump last weekend - what a struggle that was!
I'm going to reinstall the new AISIN one I bought from @Racer65 this weekend, but it got me thinking. When I removed the waterpump I ended up following a thread here that said to pull the studs.
Per cityracer's instructions, I will apply FIPG to both sides of the gasket for the water pump. I feel it will get really messy if I try to hold the water pump and gasket covered in FIPG while I try to put studs through the holes. Then on top of that, I've got to tighten everything down before the gasket sets.
Has anyone run into this issue?
Is there a more straightforward way?
Thanks!